Installation Instructions 1. If the bipod is on the weapon, make sure the weapon is UNLOADED. 2. If the bipod is on the weapon, check the weapon again and confirm it is UNLOADED. 3. Extend the legs of the bipod. 4. Unscrew the PodPaw and separate the three major components. 5. Place PodPaw Cap through bipod leg, threads down. 6. Gently pull the Insert halves apart enough to slip over bipod foot and place them over the conical foot of the bipod. 7. Screw PodPaw Base into PodPaw Cap, hand tight, do not over tighten. PodPaw may be a little stiff at first but will loosen up with use. 8. Repeat steps 4-7 for other PodPaw. Good Shooting!